Bravia KD-49XE8004 Start-up

[kecolli93]

Could someone please advise me how I can set my TV to start with the digital input (Freeview).

Since purchase it starts at HDMI 1 with the following message in the bottom right hand corner of the screen    "No signal. Check the external input or select another input using the INPUT button." That is what I find annoying.

All HDMI inputs are connected but none are active at switch on.

What I want, is to be able to switch the TV on and immediatey view the TV Digital input without having to physically select the desired input.

Any help will be greatly appreciated.

[LightFoot]

---

@kecolli93 wrote:

Could someone please advise me how I can set my TV to start with the digital input (Freeview).

Since purchase it starts at HDMI 1 with the following message in the bottom right hand corner of the screen    "No signal. Check the external input or select another input using the INPUT button." That is what I find annoying.

All HDMI inputs are connected but none are active at switch on.

What I want, is to be able to switch the TV on and immediatey view the TV Digital input without having to physically select the desired input.

Any help will be greatly appreciated.

---

Hi @kecolli93  To eliminate whatever is connected to HDMI 1, what happens if you disconnect it completely and then switch on having switched off while watching Digital TV?

[kecolli93]

Thanks for the suggestion.

However, having disconnected both HDMI 1 & 2, at switch on the TV still defaults to HDMI 1 even though nothing is connected to that input. Very annoying.

[LightFoot · Accepted solution]

---

@kecolli93 wrote:

Thanks for the suggestion.

However, having disconnected both HDMI 1 & 2, at switch on the TV still defaults to HDMI 1 even though nothing is connected to that input. Very annoying.

---

Hi @kecolli93. I would open a formal support ticket if I was you:

https://services.sony.co.uk/supportmvc/en/Contact/Email

[kecolli93]

Thanks for the link.  I will give it a try.